Cooper Security i-on40 Installationsanleitung PDF herunterladen (Seite 72)

Installer Mode Programming i-on40

Page 68

Dynamic Test Call

In dynamic testing the system makes a test call 24 hours

after the last alarm communication. To enable dynamic

testing select Communications – ARC Reporting – Dynamic

Test Call – Enabled.

Static Test Call

In static testing the system makes a test call either on:

Every day at one particular time of day or

On the same day of every week, or

On one day every month.

To make test calls at a set time every day select

Communications – ARC Reporting – Static Test Call – Daily.

From the display select a number between 01 and 24 to

choose the time of day for the call. For example, select

18 to program the control unit to make a static test call

at 6:00pm every day.

To make test calls on the same day every week select

Communications – ARC Reporting – Static Test Call – Weekly.

From the display select the day of the week on which the

call should take place. Next, key in the hour of the day

(01 to 24) on which the test call should occur..

To make test calls on one day every month select

Communications – ARC Reporting – Static Test Call – Monthly.

From the display select a number between 1 and 31 to

specify the day of the month on which the call should

take place. Next, key in the hour of the day (01 to 24) on

which the test call should occur.

For each of the three types of call, the control unit will

add or subtract up to 16 minutes at random to the hour

you specified. This is to make sure that the ARC is not

overwhelmed with a flood of test calls from systems that

have all been given the same time.

Select Communications – ARC Reporting – Static Test Call –

Disabled to disable static test calls.

Speech Dialler

The i-sd02 has a built-in speech dialler. The module can

record five speech messages using its internal

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 115 116

Keine Kommentare

Cooper Security i-on40 Installationsanleitung Seite 72