Cooper Security i-on40 Installationsanleitung PDF herunterladen (Seite 55)

i-on40 Installer Mode Programming

Page 51

System Tampers

Yes The user can reset the system after an alarm

caused by a system tamper, for example the

control unit lid opening, or a keypad being

opened.

No The installer must reset the system after a system

tamper alarm.

Note: This setting is required for INCERT approval.

DD243 (UK Only)

Note: This menu is visible only when System Options –

Restore Defaults – Country defaults is set to “UK”.

In order to program your requirements for DD243 select

System Options - DD243. The options available are:

Confirmation

When set to ‘On’ this option enables the features

designed to ensure the system complies with

DD243:2004.

Note: When using Confirmation, and the system is

programmed for Installer Reset after an alarm, the

user cannot set the system after an alarm until the

installer has carried out a reset.

Confirmation Time

This option determines the length of the confirmation

time.

After Entry

Never: The control unit turns alarm confirmation off

if the user enters by the entry door (used for

DD243:2004 clauses 6.4.2 and 6.4.4).

1 zone: The control unit starts a confirmed alarm if

the intruder activates one or more zones, not on the

entry route, after entering the premises through the

final exit zone.

2 zones: The control unit starts a confirmed alarm if

an intruder activates two (or more) zones, not on the

entry route, after entering the premises through the

final exit zone (used for DD243:2004 clauses 6.4.5).

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 115 116

Keine Kommentare

Cooper Security i-on40 Installationsanleitung Seite 55