Cooper Security i-on40 Installationsanleitung PDF herunterladen (Seite 100)

Appendix I i-on40

Page 96

Part Set Alarm Response: Siren +

Comms

(See Note 2)

Part Set Final Exit: Final exit

Part Set Entry Route: Entry Route

Strobe on Set: On

Strobe on Unset: On

FULL SET LINK

Partitions 2-4: No

SYSTEM OPTIONS

WIRED ZONE TYPE:

2 Wire FSL 2k2/4k7 (To comply with

EN50131 select this option manually

during initial power up.)

USER ACCESS:

PA keys active: No

Quick Set: No

(See Note 2)

Quick Omit: No

User code reqd: Yes

USER RESET

Zone Alarms: Yes (Note: This option

does not appear if DD243 Confirmation

is ON)

Zone Tampers: Yes (See Note 4.)

System Tampers: Yes

DD243 CONFIGURATION:

Confirmation: On (See Note 1, and Note

on page 51)

Confirmation Time: 30 mins

After Entry: 2 zones

Entry Keypad Lock: Off

Sounder: Unconfirmed

Siren on: Unconfirmed

Unconfirmed Reset: User

Confirmed Reset: User

INSTALLER NAME

Installer

INSTALLER CODE:

7890

KEYPAD TEXT:

i-on40

REMOTE NEEDS ENTRY:

Disabled

PA RESPONSE:

Audible

AUTO REARM:

Never

Note: This setting is required in order to

comply with EN50131.

SIREN DELAY:

0 min

SIREN TIME:

15 minutes

To comply with EN50131-1 Clause 8.6

minimum is 90s, maximum is 15mins.

ENTRY ALARM DELAY:

Enabled

Note: This setting is required in order to

comply with EN50131 8.3.8.2.

SUPERVISION:

On

JAMMING:

On

FORCE SET:

Off

TAMPER OMIT:

Disabled

(See Note 2)

CSID CODE

0000

SILENCE ALERTS:

User Code

MAINS FAIL DELAY:

0 minutes (see Note 2)

COMMUNICATIONS

ARC REPORTING:

Note: to comply with EN50131 you

must fit a communicator module.

Call Mode: Enabled

(See Note 2)

Phone book: empty

Account Number: 000000

Report Type: Fast Format

Fast Format channels:

Output 1: Fire

Output 2: Panic alarm

Output 3: Burglar

Output 4: Open / Close

Output 5: Omit (System)

Output 6: Alarm Abort

Output 7: Alarm conf

Output 8: Technical Alarm

CID/SIA Events:

Fire: Yes

Panic: Yes

Burg: Yes

Technical Alarm: No

Tampers: Yes

Set/Unset: Yes

(See Note 2)

Part Set: Yes

(See Note 2)

Reset: Yes

(See Note 2)

Exit timeout: Yes

Omit: Yes

RF Supervision: Yes

RF Jamming: Yes

(See Note 2)

RF Battery/PSU: Yes

(See Note 2)

Panel Battery: Yes

(See Note 2)

Mains Fail: Yes

(See Note 2)

Faults: Yes

(See Note 2)

Installer Mode: Yes

(See Note 2)

User Code Changed: No

Date/Time Reset: No

Downloading: No

Restorals:

Enabled

Send tamper as burg:

Disabled

Dynamic Test Call:

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 115 116

Kommentare zu diesen Handbüchern

Keine Kommentare