Cooper Security i-on40 Installationsanleitung PDF herunterladen (Seite 37)

i-on40 Installer Mode Programming

Page 33

You can remove the output from Partition 1 by

pressing

to change the “Yes” to a “No”.

Press

to scroll to other Partitions. Press

to assign the output to each Partition as required.

Press

when you have finished assigning outputs to

Partitions.

4. Press n to scroll down to the next output.

Polarity

This option allows you to change the polarity of the wired

outputs. There are two options:

Normal

The output is held at +12V while inactive, and at 0V

when activated.

Inverted

The output is held at 0V while inactive, and at +12V

when activated.

To change the polarity of a wired output:

1. Select Outputs – Wired Outputs.

The bottom line of the display shows the first in the

list of four available wired outputs.

2. Press u or n to select the wired output that you wish

to change and press >.

The bottom line of the display shows the word

“Name”.

3. Press n until the bottom line shows “Polarity”, and

then press >.

The bottom line of the display shows the current

polarity.

4. Press > or < to change the polarity.

5. Press Y to store any changes to the polarity.

Plug-By Outputs

The plug-by outputs are designed for use by standalone

communicators (see i-on40 Installation Guide for

connection details). You can give each output a name, a

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 115 116

Keine Kommentare

Cooper Security i-on40 Installationsanleitung Seite 37