Cooper Security i-on40 Installationsanleitung PDF herunterladen (Seite 30)

Installer Mode Programming i-on40

Page 26

5. Press Y on the i-on40 keypad to confirm that the Info

Module has learned the identity of the i-on40.

Disabling Info Modules

If you physically remove the Info Modules from a system

(for example, when a user no longer requires them) then

you may wish to stop the control unit trying to update the

Info Module’s display. The Detectors/Devices–Info Module

menu provides the Updates option for this purpose.

To disable updates on an Info Module:

1. Select Detectors/Devices – Info Module - Updates.

The bottom line of the display shows either

“Disabled” or “Enabled”. (A “*” at the beginning of

the line shows the option currently in use.

2. Press u or n to select the option you require.

When you select Enabled, the control unit carries on

transmitting to the Info Module.

When you select Disabled, the control unit stops

transmitting data to all the Info Modules.

3. Press Y to confirm the change.

The default setting for this menu option is Disabled. The

control unit changes the setting to Enabled when you

teach an Info Module the control unit’s identity.

Enabling the Ready to Set LED

The Info Module possesses a LED that glows when the

alarm system is NOT ready to set (for example, because

a detector is reporting an alarm). To disable or enable

this LED:

1. Select Detectors/Devices – Info Module - Ready-to-Set

LED.

The bottom line of the display shows either

“Disabled” or “Enabled”. (A “*” at the beginning of

the line shows the option currently in use.

2. Press u or n to select the option you require.

When you select Enabled, the control unit carries on

using the Ready to Set LED on the Info Module.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 115 116

Keine Kommentare

Cooper Security i-on40 Installationsanleitung Seite 30