Cooper Security i-on40 Installationsanleitung PDF herunterladen (Seite 27)

i-on40 Installer Mode Programming

Page 23

1. Select Detectors/Devices – Radio Keypad.

The bottom line of the display shows the first in a list

of “memory slots” for the radio keypads. If a memory

slot is occupied by a radio keypad then the bottom

line of the display shows a “*” at the beginning of the

line.

2. Press u or n to select the radio keypad you wish to

assign to a partition, then press >.

The bottom line shows the first partition. At the end

of the bottom line the display shows “Yes” if the

keypad is assigned to the partition, “No” if it is not

assigned to the partition.

3. Press < or > to change the status of the keypad.

“Yes” means the keypad is assigned to the partition.

4. Repeat steps 2 and 3 for all the other partitions you

wish to assign the radio keypad to.

5. Press Y to save your changes when you have

finished.

Once you have assigned a keypad to a partition then that

radio keypad can set and unset the assigned partition(s).

External Sirens

The 760ES external radio siren is a weather-proof battery

powered siren designed to operate on external walls. In

an alarm the control unit triggers the external siren at the

same time as the internal siren. The 760ES external siren

runs for either: five seconds, three minutes, or 15

minutes depending on the position of a link within the

sounder.

Each control unit can learn up to four external radio

sirens.

To program the external siren select Detectors/Devices –

External Siren .

Adding an External Siren

(Please read the installation guide for the external siren.)

To make the control unit learn the ID of an external

siren:

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 115 116

Keine Kommentare

Cooper Security i-on40 Installationsanleitung Seite 27