Cooper Security i-on40 Installationsanleitung PDF herunterladen (Seite 67)

i-on40 Installer Mode Programming

Page 63

1. You understand basic IP terminology.

2. You have obtained the necessary information from

your Internet Service Provider.

Unit Name

Use this option to store a unique name for the unit.

Polling IP Address

Key in the IP address of the remote polling engine. If

the ARC is not using a polling engine then leave this

option blank.

ARC IP Address

Use this option for the ARC’s main IP addresses. This

option provides two entries for storing a primary and

a secondary ARC IP address.

Account Numbers.

To store an ARC account number select Communications –

ARC Reporting – Account Numbers.

If you are programming a partitioned system then the

control unit gives you the opportunity to store an account

number for each partition. If you are programming a Part

Setting system then you can store one account number.

With CID reporting the system reports alarms using a

four digit account code.

With Fast Format reporting you can use four-, five- or

six-digit codes. The control unit pads five-digit codes to

six digits using a leading zero. The control unit leaves

four- and six-digit codes unchanged.

Note: If you need to add a letter to the account code

press the numbers keys repeatedly until the letter

you want appears on the display. See page 7.

Report Type

To choose the report type to send to the ARC select:

Communications – ARC Reporting – Report Type.

The report types available are: Fast Format, Contact ID,

SIA 1, SIA 2, Scancom SIA 3, Extended SIA 3, Contact ID

in SMS.

Fast Format Channels

(See Appendix II for a brief description of Fast Format.)

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 115 116

Keine Kommentare

Cooper Security i-on40 Installationsanleitung Seite 67