Cooper Security i-on40 Installationsanleitung PDF herunterladen (Seite 58)

Installer Mode Programming i-on40

Page 54

Web Server you must key into the Username field the

same text as you have programmed into the Installer

Name field.

Installer Code

The default Installer access code is 7890. Cooper Security

Ltd recommend that you change this code to some other

number. To change the Installer access code select

System Options-Installer Code.

The Installer code allows you to enter the Installer Menu,

and carry out an Installer reset. However, the Installer

code does not allow you to set or unset the system.

When logging into the i-on40 Web Server you must key

into the password field the same code as you have

programmed into the Installer Code field.

Keypad Text

If required the installer can key in a text message that

appears on the first line of the display in the standby

screen. This could be, for example, the name of the

installer’s company. See page 7 for hints on editing text.

Remote needs Entry

Instead of using an entry timer triggered by a Final Exit

zone to allow the user to gain access to the control unit

and unset the system, the user can employ a remote

control. To chose between either of these options select:

System Options – Remote needs Entry. The options available

are:

Enabled:

The user must first trigger an entry zone and start

the entry timer before unsetting the system with a

remote control.

Disabled:

The user can unset the system using a remote control

without first starting the entry timer.

PA Response

During a PA alarm the control unit starts communications

(provided you have a communication module fitted and

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 115 116

Keine Kommentare

Cooper Security i-on40 Installationsanleitung Seite 58