Cooper Security i-on160EX Installationsanleitung PDF herunterladen (Seite 97)

i-on160 Installer Menu Options

Page 91

Wired Keypads Use this option to test the sounders on the wired

keypads. Either: Select “All keypad sounders” to

operate all wired keypad sounders on the system at

once.

OR: Press u or n to select the wired keypads

sounders for an individual partition.

Note that options for radio sirens will not appear if the control unit has not

learned any radio sirens.

Select the type of sounder you wish to test and press Y. The sub-menu gives

you the option to test all sounders in a category at once, or to select individual

partitions and test the sounder(s) for that partition. (The display will only

present those partitions that have zones allocated to them.)

Press > to turn the sounder on. Press > to turn the sounder off again. The

display shows the word "On" when the sounder should be operating and “Off”

when the sounder should be silent.

Wired Keypad

Use this menu option to test the keypad you are currently holding (you cannot

test a keypad remotely). When you start the test the display shows the keypad

name and bus address. All four LEDs should glow. The LEDs around the

navigation should all glow red. Every time you press a navigation key the LEDs

change colour. Press all the keys one by one. The display should show you the

key you pressed. To test the PA keys press them both at the same time.

Note: While you are using the Test – Wired Keypad option activating a keypad PA

will not cause a PA alarm.

Press X to leave the test.

Radio Keypad

Please note that there is no Test menu option for the radio keypads.

If you suspect that radio keypad keys are not working then:

a) Press the A, B, C, D and Unset keys one after the other. The transmit LED

should flash for each key press. This verifies whether these five keys are

working.

b) Test all the other keys (including the two-button PA) by using valid access

codes to set/unset the system, or to generate a PA while the system is unset.

Walk test

The walk test menu provides several different ways of organising a walk test.

The options within Walk Test are:

Chime Use this option to turn a chime tone on or off. When the

chime tone is on, the keypads and loudspeakers will

sound a chime tone for each zone that triggers while

you are performing a walk test.

System This option allows you to walk round the entire system

and test all the zones.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 179 180

Kommentare zu diesen Handbüchern

Keine Kommentare

Cooper Security i-on160EX Installationsanleitung Seite 97

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Cooper Security i-on160EX