Cooper Security i-on160EX Installationsanleitung PDF herunterladen (Seite 118)

Step by Step Programming Procedures i-on160

Page 112

6. Press u or n keys to show the zone you wish to

delete.

ADD/DEL DETECTORS

*Zone 021 >

7. Press Y.

The bottom line of the display shows the first of

two options: deleting the detector ID or of

defaulting the zone.

DELETE Zone 020

Delete Detector ID>

8. Press u or n to see each of these choices.

DELETE Zone 020

Default Zone >

If you select “Delete Detector ID” then the

control unit “forgets” the ID of the detector, but

leaves any zone programming in place.

DELETE DETECTOR ID

Are you sure?

If you select “Default zone” then the control unit

“forgets” the ID of the detector and sets all the

zone programming back to default values: Type

= Not Used, no attributes.

Delete detector and

clear all zone info?

Note: Either option acts as soon as you confirm it,

and not when you leave Installer Mode.

9. Press Y to confirm your choice.

After a brief message confirming the action the

control unit has taken the bottom line of the

display shows the zone ready to learn in a new

radio detector.

ADD/DEL DETECTORS

Zone 021 >

To reinstate the detector you must teach the control unit that detector's

identity again (see page 110).

Deleting all radio detectors

1. Enter Installer Menu.

INSTALLER MENU

Detectors/Devices >

2. Press Y.

DETECTORS/DEVICES

Detectors >

3. Press Y .

DETECTORS

Add/Del Detectors >

4. Press Y .

The bottom line of the display shows the first of

the radio expanders.

ADD/DEL DETECTORS

Exp. R1-02 (R10)>

5. Press u until the bottom line of the display

shows “Delete All”.

ADD/DEL DETECTORS

Delete All >

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 179 180

Kommentare zu diesen Handbüchern

Keine Kommentare

Cooper Security i-on160EX Installationsanleitung Seite 118

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Cooper Security i-on160EX