
Step by Step Programming Procedures i-on160
Page 120
11. Press Y to save the text.
Bedroom
Name >
12. Carry on with any other programming that you
need to do. DON’T FORGET to leave the Installer
Menu in order to save the changes you have
made (see page 7 ).
Assigning a Radio Keypad to Partitions
The i-on160EX allows you to assign radio keypads to one or more of the
partitions.
Note: If you selected “Part set mode” during Initial Power-up then you cannot
assign a radio keypad to a partition (see System Options–Restore Defaults–
Factory Defaults on page 67 if you want to change the system from Part
Setting to Partitions).
1. Enter Installer Menu.
INSTALLER MENU
Detectors/Devices >
2. Press Y.
DETECTOR DEVICES
Detectors >
3. Press n until the display shows:
DETECTOR DEVICES
Radio Keypads >
4. Press Y.
RADIO KEYPADS
Add/Del Radio Kpd >
5. Press n.
RADIO KEYPADS
Edit Keypads >
6. Press Y.
The bottom line of the display shows the first in
a list of the radio keypads that have been
learned by the control unit.
RKP01 R1-01-01
Radio Kp 01 >
7. Press u or n to select the keypad that you wish
to name.
EDIT RADIO KEYPADS
Radio Kpd 02 >
8. Press Y.
The bottom line of the display shows “Name”.
Radio Kpd 02
Name >
9. Press n.
The bottom line of the display shows :
Radio Kpd 02
Partitions >
10. Press Y.
Radio Kpd 02
Partition 1 Yes
11. To allocate a radio keypad to a partition press >
or < until the end of the bottom line shows
“Yes”. To remove a radio keypad from a partition
press > or < until the end of the bottom line
shows “No”. You can allocate a keypad to more
Radio Kpd 02
Partition 1 No
Kommentare zu diesen Handbüchern