Cooper Security i-on160EX Installationsanleitung Seite 13

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 180
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 12
i-on160 Basic Programming Procedures
Page 7
If this happens key in a valid user code (not a
Set Only user code see note 1).
When you key in the last digit of the access
code the display shows “Installer Menu” on the
top line. The bottom line shows the first option
in the Installer menu: Detectors/Devices. (See
note 2.)
INSTALLER MENU
Detectors/Devices >
3. Press u or n to display more options from the
menu.
Each option appears on the bottom line of the
display in turn, for example:
INSTALLER MENU
Outputs >
4. Press > or Y to select that option of the menu.
The option you selected now appears on the top
line. If there are any sub-options for that
selection, then the first of them appears on the
bottom line. Press u or n to display the other
sub-options.
OUTPUTS
Radio Outputs >
Notes:
1. After you initially gain access to the Installer Menu, you may leave and
re-enter using the Installer access code by itself for up to 30 minutes
after you last exited the Installer Menu. After that time you will need to
enter a valid user access code to complete your entry into the Installer
Menu (note that you cannot use a Set Only user code). To disable this
feature see System Options – User Access – User Code Required on page 61.
2. If you key in the code incorrectly, the display shows the time and date
again, and gives an error tone. Key in the code again. If you key in a total
of ten consecutive incorrect codes then the system locks you out for 90
seconds.
To leave the Installer Menu at any time:
1. Press
X until the display shows:
Leave
installer mode ?
2. Replace the control unit lid (if you removed it
earlier). Ensure the control unit tamper switch
is closed.
3. Press Y to leave Installer menu.
(Press X if you do not want to leave the menu.)
The display shows:
The control unit scans the bus to check for any
devices that have been added or removed
without using the installer menu. On a large
system this may take tens of seconds.
Please wait...
When the control unit has finished scanning the
bus, the display time and date. The system is
i-on160EX
12:00 02/11/2010
Seitenansicht 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 179 180

Kommentare zu diesen Handbüchern

Keine Kommentare