Cooper Security i-on160EX Installationsanleitung PDF herunterladen (Seite 171)

i-on160

Page 165

Appendix IV: Programming a 762 or 768/769

as an Output Module

Introduction

Before You Begin

Carry out a radio site survey.

Set Up the 762 or 768

Enter Programming Mode

To enter programming for the first time (while installing a new unit):

1. Connect a suitable 12VDC power supply to the DC supply in

connector.

The display shows the version number of the software as two

alternating two-digit numbers, for example:

01 00

2. Press Select.

The display shows the first command in the menu: Manual

Learn.

To enter programming while the unit is operating:

1. Open the 762r case lid.

Note: If the unit is connected to an alarm control panel the tamper

alarm may sound.

The display is blank.

2. Press Select.

The display shows the first command in the menu: Manual

Learn.

Disable Infra-red learning

Enter pro

rammin

mode if the 762r./768r is not already

there.

3. Press Select until the display shows the Infra Red Learn

command “IR”:

4. Press Set.

The display shows E if infra read learning is enabled, or D if

infra red learning is disabled (radio learning enabled).

5. Press Select until the display shows “disable”.

6. Press Set.

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 179 180

Keine Kommentare

Cooper Security i-on160EX Installationsanleitung Seite 171