Cooper Security i-on160EX Installationsanleitung PDF herunterladen (Seite 106)

Step by Step Programming Procedures i-on160

Page 100

2. Apply 12Vdc power to the device (use the 0V

and 12V terminals on the keypad connector).

3. Hold down keys D and X at the same time. See Note below.

After a few seconds you should hear a

confirmation tone and the navigation LEDs

start flashing.

4. Release the D and X keys.

5. Close the lid, makin

sure the tamper switch

closes.

Note: DO NOT hold down D and

to delete a keypad from a system while the

keypad is still connected to the bus. Always delete keypads from a system

first by using the Installer Menu, see page 102. If you have inadvertently

erased a keypad’s address by holding down D and

then:

1. Make the control unit re-scan the bus by leaving the Installer Menu.

2. Press Y when the control unit displays “Accept all changes to bus?”.

3. Add the keypad back to the system, as described below.

To Add An Expander Or Keypad To The Bus:

1. Make sure that the expander or keypad has

the default bus address. (See page 99.)

2. Power down the system and connect the

device to the bus.

3. Power up the system.

4. Enter Installer Menu.

INSTALLER MENU

Detectors/Devices >

5. Press Y.

The display shows:

DETECTORS/DEVICES

Detectors >

6. Press n until the display shows

DETECTORS/DEVICES

Address Bus Device>

(The rest of these instructions assume you are

adding a wired expander. The same

instructions will also work for a radio expander

or wired keypad.)

8. Press Y .

The display shows a message telling you to

press the address request buttons on the bus

device.

Press addr button(s)

on bus devices

9. For Expanders:

Go to the expander. Remove the expander lid.

Hold down the Request/Delete Address button

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 179 180

Kommentare zu diesen Handbüchern

Keine Kommentare

Cooper Security i-on160EX Installationsanleitung Seite 106

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Cooper Security i-on160EX