Cooper Security i-on160EX Installationsanleitung PDF herunterladen (Seite 96)

Installer Menu Options i-on160

Page 90

you can key in the port numbers that Downloader “listens”

to on the remote PC for the primary and secondary IP

addresses.

Secure Callback

(This option appears only when the i-sd02 or i-gsm02 module is fitted.)

Select Downloading - Secure Callback to allow Downloader to use a third callback

number (independent of the telephone numbers in the Downloading – Phone

Book option). Before making a Downloader connection, the remote PC operator

keys in the third callback number. Once connected Downloader transmits the

number to the control unit. The control unit then uses that number to call back

to the remote PC.

Modem Baud Rate

(This option appears only when the i-sd02 or i-gsm02 module is fitted.)

Over some noisy telephone lines Downloader communicates more effectively

using a slower Baud rate from the control unit. Select Downloading – Modem

Baud Rate to change the baud rate to 300 baud.

Test

The i-on160EX provides three options within the Installer Menu to help in

testing: the Test option itself, the View Log option to see what events have

been recorded, and the About option so that you can check on the release level

of the software.

If you think that part of the system is not working correctly then you can use

the Test option to test various peripherals.

The Test option also lets you check the identity of Remote controls, Panic

Alarms and Tags.

You can test each part listed in the Test menu as follows:

Sirens and Sounders

This option allows you to test all the warning devices connected to the control

unit. The option is divided into sub-menus allowing you to test specific types of

sounder, as shown in the table below:

Ext. Radio Sirens

his option presents a list of the learned-in radio

sirens. Select a siren for testing by pressing u or n.

Note that both siren and strobe should operate.

Wired Sirens This option allows you to operate all outputs

programmed as “Siren” and “Strobe”.

Either: Select “All Sirens” to operate all sirens at once.

OR: Press u or n to select the sirens for an individual

partition.

Loudspeakers With this option you can test any loudspeakers

connected to the system. Either: Select “All

Loudspeakers” to operate all loudspeakers at once.

OR: Press u or n to select the loudspeakers for an

individual partition.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 179 180

Kommentare zu diesen Handbüchern

Keine Kommentare

Cooper Security i-on160EX Installationsanleitung Seite 96

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Cooper Security i-on160EX