Cooper Security i-on160EX Installationsanleitung PDF herunterladen (Seite 112)

Step by Step Programming Procedures i-on160

Page 106

Followed by:

The navigation keys on the keypad glow red.

REPLACE EXPANDER

Exp. W1-04 Add

10 a) Power down the system (both mains and

battery).

b) Remove the old expander.

c) Connect the new expander.

Note: The new expander must be of the same type

as the one you removed. Make sure that you

replace an EXP-R30 with an EXP-R30.

d) Power up the system (connect the battery,

close the control unit lid to ensure the tamper

switch is closed, then apply mains power).

The keypad display shows:

The navigation key LEDs glow red to show that

there is an alert for the disabled expander.

i-on160EX

12:43 02/11/2010

11. Re-enter Installer Men, and navigate back to

Detectors/Devices – Wired Expander – Replace

Expander (follow steps 1 to 6).

The display shows:

REPLACE EXPANDER

Exp. W1-04 Add

12. Press Y .

The display shows:

Press addr button(s)

on bus devices

13. Go to the expander. Remove the expander lid.

Hold down the Request/Delete Address button

for at least three seconds.

After three seconds the expander gives a

confirmation tone (two beeps) and its display

shows the address allocated by the control unit.

In this example the address is 1-04; the control

unit has allocated the address of the old

expander.

1- followed by 04

The keypad display shows for a few seconds:

Followed by:

W1-04 replaced

REPLACE EXPANDER

Exp. W1-04 Remove

14. Leave the Installer Menu.

The new expander now has the programming of

the old expander.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 179 180

Kommentare zu diesen Handbüchern

Keine Kommentare

Cooper Security i-on160EX Installationsanleitung Seite 112

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Cooper Security i-on160EX