Cooper Security 9751 Installationshandbuch PDF herunterladen (Seite 97)

4. Programming

496964 Page 89

80: Forbikobler Chime

This Command links the bell push on the Forbikobler keypad to the Chime on

the system, so that pressing the bell operates the sounders.

Option

0 Off. Pressing the bell push does not operate the sounders (default).

1 On. Pressing the bell push operates the sounders.

Note: This is not available in a partitioned system.

81 to 84: Output n Type

Note: Command 84 applies only to the 9851, as only it has a fourth output.

These Commands program the control unit's panel outputs. They take two

digits to select the output type (see below) and have the following defaults:

Command Output Control unit Default outputs

81 1 All 00 Bell

82 2 All 08 Strobe

83 3 All 03 Set Latch

84 4 9851 03 Set Latch

Option

00 Bell: active during an alarm. Use Command 41 to set Bell Delay and

42 to set Bell Duration. In a partitioned system, this type is activated

when any partition is in alarm. If Alarm Confirmation (Command 89) is

enabled, use Command 162 to set whether the bell is sounded on the

first or confirmed alarm.

01 EE Follow: active when Entry or Exit Time starts and inactive when

the time expires or is terminated. The output can be used for a

separate Entry/Exit buzzer. It will not give a tone during part set if the

exit mode is silent set or instant set.

02 Armed Lamp: active continuously while the system is full or part set.

03 Set Latch: active when the system is set and inactive when the

system is unset or an alarm condition occurs. It is active for one

second when a reset is performed or the control unit leaves

programming mode. It is also active during Walk Tests.

04 Shock Reset: used to reset shock sensors (for example, the "Viper").

The output is triggered by the control unit at the start of the Exit Time

and remains active for five seconds.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 147 148

Keine Kommentare

Cooper Security 9751 Installationshandbuch Seite 97