Cooper Security 9751 Installationshandbuch PDF herunterladen (Seite 83)

4. Programming

496964 Page 75

To unset the system, the user turns the lock switch to "unlocked"

(which closes the lock switch contacts). The keypads start to emit a

continuous tone. At this point, the user can lock the lock switch again

without causing an alarm. When the user opens the Final Exit zone,

the control unit starts the entry timer. The user completes entry by

unsetting the system in the normal way.

When the user unlocks the lock switch, the control unit disables Alarm

Confirmation. If the user locks the lock switch without starting the

entry timer, the control unit enables Alarm Confirmation again.

If an intruder opens the Final Exit door without first unlocking the lock

switch, the control unit immediately starts an unconfirmed alarm. If the

intruder goes on to violate another zone and Alarm Confirmation is

enabled, the control unit sends a confirmed alarm.

Note: The keypads give a double "beep" at the end of all setting modes.

If you select Timed (option 0), Terminated (option 1) or Final Door (option 2)

exit modes, the system allows a seven-second settling time after pressing an

Exit Terminate button or closing a final door.

40: System Auto Rearm

This Command sets the number of times that the system will rearm all closed

zones when the bell duration expires. If you select option 0, the system will

not rearm (it will go into alarm only once). Select option 1 to rearm once, 2 to

rearm twice, 3 to rearm three times or 4 to rearm always.

Use this Command in conjunction with Command 35, First Circuit Lockout.

If the system has rearmed, the control unit gives an audible internal alarm

instead of the normal entry tone when a user enters the system through the

Entry Route.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 147 148

Keine Kommentare

Cooper Security 9751 Installationshandbuch Seite 83