Cooper Security Homelink 75 Betriebsanweisung PDF herunterladen (Seite 73)

7510r Programming Reference - Reporting

Page 69

Note: There are a total of five voice messages available.

The control unit always sends the Home Message at

the beginning of every speech report. The control

unit then sends messages 1, 2, 3 or 4 to the

telephone numbers you selected.

Call Acknowledge

If the called party answers a speech dialler call, then they

can end the call by sending back a DTMF ‘5’ (see page

62).

With Call Acknowledge enabled the control unit ends the

call when it receives a DTMF ‘5’. If the control unit does

not receive a DTMF ‘5’ then it attempts to call again (up

to three times).

With Call Acknowledge disabled the control unit stops

further call attempts to that number as soon as it detects

a call being answered. The called party can use DTMF ‘5’

to close the call down.

Note that after receiving a DTMF ‘5’ the control unit will

go on to call any other programmed speech dialler

numbers.

To prevent calls to other programmed speech dialler

numbers the called party can acknowledge a call by

sending back a DTMF ‘9’. When the control unit receives

the ‘9’ it stops all further call attempts.

SMS Reporting

The control unit can send alarm reports by SMS message

to any of four telephone numbers. Each alarm report is a

single SMS message, comprising:

A Home Message and a text message. You must

program the control unit with the content of these

messages.

The text of the log entry that corresponds to the event

causing the alarm.

The time and date of the alarm.

The zone name of the zone causing the alarm.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 83 84

Keine Kommentare

Cooper Security Homelink 75 Betriebsanweisung Seite 73