Cooper Security Homelink 75 Betriebsanweisung PDF herunterladen (Seite 66)

Programming Reference - Reporting 7510r

Page 62

If you select Enabled the for full alarm response the

control unit sends tampers as burglary (BA) and sends

Contact ID 130 in place of Contact ID 137.

Social Care Reporting

The control unit sends a social care alarm message for

the following types of alarm:

Emergency

A user presses a button on a pendant. The control

unit then reports to the social care station with an

EMERG BUTTON event (SCANCOM channel 2).

Activity

A zone with the Activity Monitoring attribute has been

triggered.

While the system is unset the control unit checks that

this zone is reporting activity. If the zone is quiet for

longer than a pre-programmed time (see page 73)

then the control unit starts a medical alarm and

reports to the social care station with an INACTIVITY

event (SCANCOM channel 3).

If the system is set then the Activity Monitoring zone

acts as a normal alarm.

The report sequence is as follows:

1. The control unit reports to the social care station if

social care reporting Call Mode is ON. The report

includes a SCANCOM channel 8 to show that a two

way speech path is available.

The control unit opens a two-way speech channel at

the end of the report and leaves it open until the

control unit receives a DTMF ‘5’ command or a

timeout occurs. The social care station can send

commands to the control unit by using DTMF tones

during the 2-way speech call. The commands

available are:

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 83 84

Keine Kommentare

Cooper Security Homelink 75 Betriebsanweisung Seite 66