Cooper Security Homelink 75 Betriebsanweisung PDF herunterladen (Seite 24)

Programming Reference - Detectors 7510r

Page 20

Entry Route.

Use this zone type for detectors sited between the

Final Exit door/detector and the control unit. If an

‘Entry Route’ zone is violated when the system is set,

an alarm will occur. If the entry/exit timer is running

when an Entry Route zone is violated then no alarm

occurs until the entry/exit timer expires.

Note: If you give an Entry Route zone the Part Set

attribute then you can program that zone to behave

like a Final Exit zone if the user part sets a partition

holding the zone. See page 37.

Final Exit.

Zones of this type should be the last detector to be

activated on exit, and must be the first to be

activated on entry. You can use zones of this type to

finally set the system, or to start the entry procedure.

See page 35 to set the exit mode type.

Note: If you give a Final Exit zone the Part Set attribute

then you can program that zone to behave like a

Normal Alarm zone if the user part sets a partition

holding the zone. See page 37.

24 Hour.

This zone causes an internal alarm if activated when

the system is unset, and a full alarm if the system is

set.

Fire.

Smoke or heat detectors connected to fire type zones

cause the sirens to give a distinctive fire signal

(internal sounders pulsing “Dee Dah Dee Dah...”).

Fire alarms operate whether the system is set or

unset, and will always trigger communications, if

enabled.

PA.

Operating a device programmed as ‘PA’ (Panic Alarm)

will start either a silent alarm transmission to the

Alarm Receiving Centre (ARC), or an audible alarm,

depending on how you have programmed PA

Response, (see page 41). PA alarms operate whether

the system is set or unset.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 83 84

Keine Kommentare

Cooper Security Homelink 75 Betriebsanweisung Seite 24