Cooper Security M2000 Betriebsanweisung PDF herunterladen (Seite 61)

Engineering Manual Engineer Menu 1-4

The control unit operates the General Fault System Output at the same time as the RF

Jammed System Output.

151 – Tx Low Battery

The control unit operates this output when any MRNode reports a wirefree detector with

low battery. (There is a separate output type for Telecommands and PAs.) The output

remains on until all MRNodes stop reporting detectors with low batteries.

The control unit operates the General Fault System Output at the same time as the TX Low

Battery System Output.

152 – Telecommand Low Battery

The control unit operates this output when any MRNode reports a telecommand or PA

with low battery. The output remains on until all MRNodes stop reporting telecommands

or PAs with low batteries.

The control unit operates the General Fault System Output at the same time as the

Telecommand Low Battery System Output.

153 – Set Pulse

The control unit switches this output on for 10 seconds when a user sets any ward.

154 – Unset Pulse

The control unit switches this output on for 10 seconds when a user unsets any ward.

Ward Event Output Types

The following events are applicable if you have chosen the output to follow a specific ward:

00 – Bell-SAB

Activates when the selected ward is in alarm and the control panel bell output is on, and

deactivates when the bell output is off. The bell output may be activated on a confirmed

or unconfirmed alarm, depending on whether Bells on Confirm or Bells on Unconf is

selected (page 90).

01 – Strobe

Activates when the selected ward is in alarm and the control panel strobe output is on;

deactivates when the selected ward is reset.

02 – Switch 12

Activates when the selected ward is set; deactivates when the selected ward is in alarm, its

Entry Delay timer (page 61) is running or the ward is unset. This output is normally used as

an input to latching detectors.

03 – Det. Reset

Deactivates for approximately 4 seconds when a user code is entered to set the first ward.

The output is used to reset latching detectors (smoke detectors, shock sensors, etc.).

04 – Walk Test

Activates when the selected ward is walk tested (User option 1-1-2); deactivates when the

walk test is exited.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 179 180

Keine Kommentare

Cooper Security M2000 Betriebsanweisung Seite 61