Cooper Security M2000 Spezifikationen PDF herunterladen (Seite 10)

10 M2000 Installation Instructions

used, the digital communicator must be housed within

the control panel, since the +12Vdc output is unfused.

If required, you can use the 8600EUR-00 Relay

Expansion Card to provide eight voltage free relay

contacts, driven by the digital communicator outputs.

See the 8600 Installation Instructions for details.

Note that the hardwired digital communicator outputs

are defaulted to +12V inactive 0V active (+ve

removed). This will energise the relays on the 8600. If

you wish to change this use option 1-9-1-07 to invert

the digi outputs.

Transistor Outputs

("7" in Figure 2.)

The programmable transistor outputs provide control

for external equipment such as LEDs, buzzers and

relays. The following outputs are provided:

• Two switched-negative outputs (-3 and -5). Each

can switch from 12Vdc to 0V on activation, and is

able sink up to 500mA from a 12Vdc source. See

Figure 11 for examples.

• One switched-positive output (+4). This switches

from 0V to 12Vdc on activation, and can deliver up

to 500mA to an external load. See Figure 12 for

examples.

Each output can be programmed to activate when, for

example:

• There is an alarm in a specified zone.

• There is a panic alarm.

• Mains is disconnected from the control panel.

• A specified user passcode is entered.

• A combination of specified conditions occur.

The

M2000/M800/M750 Engineering Manual

provides

full details of output programming.

Re l a y

Sm o ke

Dete c to r

Relay available from

RS c omponents

P/No. 351-982.

Capable of switching

mains voltag es

+ 12 V

Aux 12 V

-ve O/P

(Programmed as Alarm / Bell / etc)

(Programmed as Detector Reset)

12V Buzzer

RS Part No. 245-051

1K0 Ohm Resistor

LED (Light Emitting Diode)

-Ve O/P

Aux 12V

Diode (IN4001)

Figure 11: Examples of using Switched-Negative Outputs

Re l a y

Sm o ke

Detec tor

Relay available from

RS c omponents

P/No. 351-982.

Capable of switching

mains voltag es

+ 12 V

Aux 0V

+ve O/P

(Programmed as Alarm / Bell / etc)

(Programmed as Detector Reset)

Aux 0V

1K0 Ohm Resistor

12V Buzzer

RS Part No. 245-051

LED (Light Emitting Diode)

+ve O/P

Diode (IN4001)

Figure 12: Examples of using Switched-Positive Outputs

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Cooper Security M2000 Spezifikationen Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Cooper Security M2000