Cooper Security i-on16 Installationsanleitung Seite 9

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 90
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 8
i-on16 1. Introduction
Page 9
into protected areas. Readying the system to start an alarm when
someone moves into a protected area is called “setting” the
system. Disarming the system so that people can move freely is
called “unsetting” the system.
Alarms and Reset
When the system starts an alarm it usually includes activating
sounders and strobes and sending messages to an Alarm
Receiving Centre (ARC). The ARC may then call the police or
other security service to come and investigate the alarm.
Before you can set the system again you must silence the
sounders and then “reset” the system so that it is ready for
setting again (see page 16 for instructions). Please note that your
Installer may have programmed your system so that although
you can silence the sounders, you cannot reset the system
yourself, but have to call the Installer to come and do it for you.
Security Levels
The installer can program the control unit to provide four levels of
security: Full Set and three different Part Sets. Any user can put
the alarm system into any of the security levels. Each security
level is a collection of one or more detectors that monitors a
different area. The highest security level is called Full Set, and
includes all the detectors. There are three other security levels
called Part Set B, C and D. For example, in a small shop Full Set
might monitor the whole premises, while Part Set B might
monitor just the store room and rear doors.
24 Hour Alarms
The control unit can also monitor detectors that are nothing to do
with the movements of people: fire and smoke detectors, flood
sensors, Hold Up Alarm buttons, or monitors for machinery (for
example freezers). These are collectively known as “24-hour
alarms” because they can cause an alarm 24 hours a day: it does
not matter whether a user has set or unset the system.
Seitenansicht 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 89 90

Kommentare zu diesen Handbüchern

Keine Kommentare