Cooper Security i-on16 Installationsanleitung PDF herunterladen (Seite 19)

i-on16 2. Alarms

Page 19

When you talk to the alarm company, they will ask about the

circumstances of the alarm, and also for the code you recorded

from the display. If the alarm company decides that an engineer

does not need to visit you, then they will give you another four

digit code (the “anti-code”).

Key in the anti-code at the keypad. The system will reset, and

you can carry on using it as before.

Accidental Alarms

Your Installer may have programmed your alarm system so that

if you set off an alarm accidentally then you have a short time

(usually 90 seconds) to cancel the alarm. Go immediately to a

keypad and key in your access code. If you do this within the

time limit then the alarm system will send an “Alarm Abort”

message to the alarm receiving centre.

Ask your Installer how much time they have programmed to allow

you to cancel an alarm.

Speech Messages

Note: This facility requires fitting a communications module to

your alarm system, ask your installer for more details.

As well as making an audible signal, the installer can program the

control unit to send pre-recorded voice messages over the

telephone network. These messages can go to a person

nominated to monitor alarm calls.

Each message has two parts: a Home section that identifies your

system, and an alarm section that gives the nature of the alarm.

The control unit may be programmed to send the speech

message to several telephone numbers.

Acknowledging a Speech Message

If the control unit has Call Acknowledge enabled (ask your

installer), then the person receiving speech messages from the

alarm system can control the link by pressing buttons on their

telephone key pad. The commands available are:

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 89 90

Keine Kommentare

Cooper Security i-on16 Installationsanleitung Seite 19