Cooper Security i-on16 Installationsanleitung PDF herunterladen (Seite 27)

i-on16 3. Setting and Unsetting

Page 27

One of four LEDs glows to show

which part of the system is set.

Note: The installer may have

disabled the LEDs to ensure

that the alarm system

meets the appropriate

standards.

In addition, the installer may have

programmed the system to briefly

flash the strobe light on the

external sounder when the system

sets.

Changing Your Mind

If you want to stop setting

then press (unset key).

If the System Will Not Set

Normally, the system will set only when all the detectors are

“quiet”, that is: not reporting any activity.

If you have the final exit door open, or if you trigger one of the

detectors on your exit route, then the keypad and internal

sounder will give an interrupted setting tone (this is normal).

Make sure that you close all the doors on your exit route and the

final exit door as you leave. The interrupted tone will change to a

continuous exit tone, and the system will set normally.

If you try to set when one or more detectors NOT on your exit

route are still active then the display shows the words “SETTING

FAULTS”. The bottom line of the display tells you which zone is

active, for example see Figure 5.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 89 90

Keine Kommentare

Cooper Security i-on16 Installationsanleitung Seite 27