Cooper Security 9752 Installationsanleitung PDF herunterladen (Seite 9)

9752 Installation Guide 1. Introduction

11976870 Page 5

9941 and 9943 Keypads

AB CD

123

456

7890

Figure 2. 9941 and 9943 Keypads

The control unit supports the connection of 9941 and 9943 keypads. The

9943 has a built-in wide-area proximity reader and connections for an external

panic alarm switch. Both have a two-line 16-character Liquid Crystal Display

(LCD) that can display alarm information, programming settings and other

information. There are three LEDs that have the following functions.

Note: Depending on how the system is set up, the LEDs may not operate until

a user code is presented.

Alert lamp – Flashes to highlight unacknowledged alert, glows for

acknowledged conditions, and goes out when all conditions have

been rectified.

s Service lamp – Glows if the system needs an installer reset.

a Mains lamp – Glows when using mains power. Flashes when using

the stand-by battery.

Expanders

You can attach up to three hardwired or radio expanders to the control unit to

expand the number of zones to a maximum of 32. You can use a combination

of the two types.

Hardwired Expanders

The 9954 hardwired expander enables you to connect wired detectors to the

control unit. Wired detectors can be connected in the following ways:

1. Four-wire Closed Circuit Loop (CCL).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Keine Kommentare

Cooper Security 9752 Installationsanleitung Seite 9