Cooper Security 9752 Installationsanleitung PDF herunterladen (Seite 34)

3. Installation 9752 Installation Guide

Page 30 11976870

Line Monitoring for the Internal Communicator

The control unit provides a line monitoring function to check that a telephone

line connected directly to the control unit is working, and to indicate a line

failure if it is not. While enabled, this function continually checks the line

voltage to ensure that the line is connected. If it detects a failure, the system

gives the Line Fault Response selected with Command 106.

Test Calls

The control unit can be programmed to make test report calls to an ARC.

"Static" test calls can be programmed to occur at set times or intervals.

"Dynamic" test calls occur 24 hours after the last call made by the unit. See

the Programming Guide for details on how to program these functions with

Commands 105 and 108.

Statutory Information

Applications

The built-in communicator is suitable for connection to the following types of

networks:

(a) Direct exchange lines (PSTN) supporting DTMF (tone) dialling.

(b) PABX exchanges (with or without secondary proceed indication).

Note: The built-in communicator is not suitable for connection as an extension

to a pay-phone or to 1 + 1 carrier systems.

Approval

The built-in communicator is manufactured to meet all European Economic

Area telecommunication networks requirements. However, due to differences

between the individual PSTNs provided in different countries, the approval

does not, of itself, give an unconditional assurance of successful operation on

every PSTN network termination point.

The built-in communicator has been approved for the following usage:

(a) Automatic call initialisation.

(b) Operation in absence of indication to proceed.

(d) Modem.

(e) Serial connection.

(f) Multiple repeat attempts.

(g) Line status monitoring.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

Keine Kommentare

Cooper Security 9752 Installationsanleitung Seite 34