Cooper Security 9651 Installationshandbuch PDF herunterladen (Seite 43)

9651 Programming - Programming Commands

11772232 Page 39

Value Attribute Valid for Description

X2

Soak Test (S) Normal Alarm

(NA)

Entry Route

(ER)

24-hour (24)

Shock Analyser

(SA)

Use this zone attribute if you want to place on

long-term test a detector that you suspect is

giving false alarms. Zones with this attribute

are disabled for 14 days after you return the

control unit to user mode. If the zone is

opened while the system is set (or at any time

for a 24-hour zone), the control unit logs the

event as a "Soak Fail Znn" (nn = zone

number) without sounding any bells or starting

signalling. The control unit returns the zone to

normal use after 14 days, even if the system

is set at the time.

X3

Double Knock

(D)

Normal Alarm

(NA)

Entry Route

(ER)

For zones with this attribute, no action is

taken on first activation. To cause an alarm,

the zone must be activated twice within a five-

minute period or remain open for longer than

10 seconds. An alarm will also occur if

another double-knock zone is activated within

five minutes of the first.

Programming a zone as "Double Knock" is a

way of reducing false alarms caused by

environmental changes but is not normally

recommended. Do not apply "Double Knock"

to radio zones with a PIR detector. The radio

PIR detector uses a lockout timer and will not

send a second activation within the Double

Knock period.

X4

Omit Allowed

(O)

All When applied to a zone, this attribute allows

the user to omit the zone when setting the

alarm. Do not allow the user to omit PA

zones.

Do not apply this attribute to an FE zone if

there is no ER zone present.

X5

Do Not Use.

X7

The meaning of this attribute depends on the zone type:

Shock

Analyser

Sensitivity

Shock Analyser

(SA)

You can set this attribute only for a zone of

type SA, and only zones 1, 2, 3 and 4 support

this type. To set the sensitivity of a shock

sensor zone, enter a digit in the range 1 (least

sensitive) to 6 (most sensitive). You must

enter the whole sequence; for example, to set

the sensitivity to 3, press X73

Entry Timer

Number

Final Exit (FE)

Entry Route

(ER)

Forbikobler

(FB)

To select which of the four entry timers (set

up using Commands 201–4, as described on

page 65) are used for the zone, enter a digit

in the range 1 to 4. You must enter the whole

sequence; for example, to select Entry Timer

3, press X73

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 87 88

Kommentare zu diesen Handbüchern

Keine Kommentare