Cooper Security 9651 Installationshandbuch PDF herunterladen (Seite 40)

Programming - Programming Commands 9651

Page 36 11772232

The following table shows the letters generated by each key on the keypad.

1 7 P Q R S

2 A B C Æ Å Ä 8 T U V

3 D E F 9 W X Y Z

4 G H I 0 Space ' ( ) : . - ! &

5 J K L C Move right

6 M N O Ø Ö D Move left

Zone Types

The following table shows the values available for zone type.

Value Type Description

00 Not Used

(NU)

Identifies zones that are not used. The system ignores zones of

this type. It is not necessary to link the circuit or anti-tamper

connections.

01 Panic Alarm

(PA)

Operating a device programmed as "Panic Alarm" will start

either a silent alarm transmission to the Alarm Receiving Centre

(ARC) or an audible alarm, depending on how you have

programmed PA Response (see Command 30). PAs operate,

whether the system is set or unset.

02 Fire (FR) Smoke or heat detectors connected to FR type zones cause the

speakers to give a distinctive fire signal (internal sounders

pulsing "Dee Dah Dee Dah..."). Fire alarms always operate,

whether the system is set or unset, and always trigger

communications if fitted.

03 Normal Alarm

(NA)

A zone programmed as "Normal Alarm" will start an alarm if

activated while the system is set.

04 24-hour (24) This zone causes an internal alarm if violated when the system

is unset, and a full alarm if the system is set. If the Installer

programs 24-hour zones with "Omit Allow", the user can omit

24-hour zones in Day mode. The control unit reinstates all 24-

hour zones if anyone sets the system.

05 Final Exit (FE) Zones of this type must be the first to be activated on entry. You

can use them to set the system using the Final Door Set exit

mode. Use Command 39 to set the exit mode for the zone (page

44). Use zone attribute X7 to select an entry timer for the zone

(page 39) and Commands 201–4 (page 65) to set up the entry

timers.

06 Entry Route

(ER)

Use this zone type for detectors sited between the Final Exit

door/detector and a keypad. If an "Entry Route" zone is violated

when the system is set, an alarm will occur. If the Entry/Exit

timer is running when an Entry Route zone is violated, no alarm

occurs until the Entry/Exit timer expires. Use zone attribute X7 to

select an entry timer for the zone (page 39) and Commands

201–4 (page 65) to set up the entry timers.

07 Shock

Analyser (SA)

You can apply this zone type to zones 1 to 4. The system will

not accept this type for zones 5 to 8. Use zone attribute X7 to

set the sensitivity for the zone (page 39).

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 87 88

Kommentare zu diesen Handbüchern

Keine Kommentare

Cooper Security 9651 Installationshandbuch Seite 40

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Cooper Security 9651