Cooper Security M-Series Bedienerhandbuch PDF herunterladen (Seite 57)

4. Programming

496478 51

(which represents the “R” or Recall button on a tel-

ephone) which is detected by the exchange as a request

for a new clean line. With the new line available, the

communicator then attempts to connect to the pre pro-

grammed receiver number.

Download Mode (Command 110)

The 9750 can be programmed from a PC using <Downloader> software. You

can connect the PC to the control unit over the telephone network.

Key in 110 Y Y to manually accept a call from the PC.

You will also need to use commands 112, 113. (Note that Secure callback

does not work with this option.) The control unit will leave command 110 if

<Downloader> does not make a call within 30 minutes.

While the control unit is connected to the PC you can upload its programming

configuration into the <Downloader> in order to inspect it. Using

<Downloader> you can change the configuration and then transmit the new

configuration back to the control unit. If you do not wish to change the con-

figuration you can simply monitor the state of the control unit and zones from

the PC.

Use command 114 if you want the control unit to answer incoming calls from

<Downloader> without an engineer being present.

Rings to Answer (Command 112)

Use this option to set the number of rings that the system waits before

answering an incoming call from the remote PC. See “Programming Com-

mands” for the available options.

Answer on One Ring (Command 113)

(Answer phone defeat) Use this feature if the alarm system shares a line with

other equipment.

One ring off (0) Disabled

One ring on (1) <Downloader> “warns” the alarm system that a call is

coming by ringing the alarm system number, waiting for

between one and two rings and then hanging up. The

alarm system now knows to expect a call within the next

10 to 90 seconds. <Downloader> then rings the alarm

system again, within 10 to 90 seconds. The alarm system

answers after the first ring.

Note: When using "Answer on 1 Ring" set the number of rings in "Rings to Answer"

(C112) to a higher number than that used by the equipment sharing the

telephone line with the alarm system. If you do not, then the other equipment

will never answer any incoming calls.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 70 71

Keine Kommentare

Cooper Security M-Series Bedienerhandbuch Seite 57