Cooper Security M-Series Bedienerhandbuch PDF herunterladen (Seite 42)

4. Programming

36 496478

Leaving Programming Mode

When all programming has been completed:

1. Key-in ‘99 Y’ at the keypad

The display shows: 99:Exit Eng ?

2. Press Y.

The display shows: 99:Checking Sys

followed by the time and date.

The system is now in user mode.

Note: If there is a fault on the system , for example an open tamper circuit, the

display shows this and will not return to Day mode. Press

(Clear) and rectify

the faults.

Engineer Reset

To perform an Engineer Reset:

1. Check that the display is showing the alarm condition.

2. Key in 0 followed by the Engineer’s code (default 7890), followed by 99 YY.

The display shows the time and date.

Re-entering Programming Mode

You can go back into programming mode whenever the system is unset and

not in alarm:

1. Key in 0 followed by the Engineer’s code (default 7890).

The display shows: Installer Mode

You are now in programming mode.

Restoring the Access Codes (1st stage reset)

If the user and/or engineer codes are lost, then:

1. First remove mains power and then open the case and disconnect the

battery.

2. Identify the NVM Reset pins on the main pcb (see Figure 4).

3. Short the Reset pins together using a small wire link.

4 Reconnect the battery.

5. Remove the short from the Reset pins.

The control unit loads the factory default access codes:

User 1: 1234.

Engineer: 7890.

6. Close the control unit and apply mains power.

7. Carry out an engineer reset.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 70 71

Keine Kommentare

Cooper Security M-Series Bedienerhandbuch Seite 42