Cooper Security i-on40 Bedienungsanleitung PDF herunterladen (Seite 23)

i-on40 Administration

Page 19

If you have a proximity tag and want to know who it belongs to

then use the Test - Proximity Tag menu option, see page 23 .

Remote controls

To allocate a remote control to a user:

1. Enter the Menu and select Users - Edit User - User(nn) - Remotes.

Note: If the user already has a remote control allocated to them

then the screen will display “Delete Remote?”. See page

20.

The display asks you to press one of the buttons on the

remote control.

2. Press any button on the remote control that you wish to

flash.

When the remote control transmits, the control unit learns

the identity of the remote control and registers it to the user.

If you do not wish to register a remote control press X.

If the control unit has already learned that remote control then

you will hear a low tone and the display tells you that the remote

control is already in use.

If you have a remote control and want to know who it belongs to

then use the Test - Remotes menu option, see page 23 .

Panic Alarms (PA)

A PA is a two button transmitter, used to start a Panic Alarm. To

activate the transmitter you must press both buttons at the same

time. On some models a third button acts as a lock so that you

can prevent the PA going off when carrying it in your pocket.

Note: While you are registering a new PA the control unit will not

respond to an alarm signal from any PA it has already

learned.

To allocate a panic alarm to a user:

1. Enter the Menu and select Users - Edit User - User(nn) - Panic

Alarm.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Keine Kommentare

Cooper Security i-on40 Bedienungsanleitung Seite 23