Cooper Security 9651 Betriebsanweisung PDF herunterladen (Seite 13)

2. Everyday Operation

11980075 Page 13

Other Problems

The system informs you of problems through alerts. These are warnings

communicated through the keypad display and lamps. If your system is set up

to hide status information after 30 seconds

, enter an access code or present

a tag to activate the keypad display and lamps.

Depending on the nature of the problem, you may need to reset the system or

call an installer to do this for you (see page 16). Your installer may have set

up your system to enable you to override some faults

, in which case you will

be able to set the system while the fault is still present. If the display shows

"Set" underneath the alert message, press y to continue with setting.

If an installer reset is required, the control unit lights the s lamp and the

keypad sounds a repeating "beep" to warn you. If the fault disappears, the

lamp goes out but the tone continues until you enter your access code. If the

fault persists and cannot be overridden, the display shows "Call Installer".

A mains power failure is an example of a technical fault that may be resolved

without intervention in the alarm system. A stand-by battery failure is an

example of a technical fault that requires an installer to visit.

If an alert indicates a communications failure (for example, "Plugby Line Fail"),

you may be able to set the system but then it may not be able to report any

alarms to the ARC.

For more information on viewing and acknowledging alerts, see page 18.

Installer Command 28

Installer Commands 134 to 140

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Keine Kommentare

Cooper Security 9651 Betriebsanweisung Seite 13